[smartmontools-support] support SiliconMotion 3282 usb bridge

[Christian Franke]

Franz Volkovic wrote:
> Thank you for pointers, tried combinations again, this one works
> (something I do different than before? Probably I'm just stupid... :-/ )
>
>
> # smartctl -d scsi -T permissive -T permissive -T permissive -T permissive -s on -x /dev/sdb
>
> smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.10.17]
> Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org
>
> === START OF INFORMATION SECTION ===
> Vendor:               JetFlash
> Product:              Transcend 256GB
> Revision:             1100
> Compliance:           SPC-4
> User Capacity:        250.054.967.296 bytes [250 GB]
> Logical block size:   512 bytes
> LU is resource provisioned, LBPRZ=0
> scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
> ...
> === START OF READ SMART DATA SECTION ===
> SMART Health Status: OK
> Current Drive Temperature:     0 C
> Drive Trip Temperature:        0 C
>
> Error Counter logging not supported
>
> scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
> Device does not support Self Test logging
> Device does not support Background scan results logging

This is the "SCSI view" of the drive which always works somehow but is 
mostly useless as this does not support ATA/NVMe-like SMART info.

Please answer this question from my last mail:

> Which -d options were tested and did not work?
> See: https://www.smartmontools.org/wiki/USB
> (Note that the device may use NVMe instead of ATA internally)


Thanks,
Christian