[smartmontools-support] support SiliconMotion 3282 usb bridge

[Franz Volkovic]

Thank you for pointers, tried combinations again, this one works
(something I do different than before? Probably I'm just stupid... :-/ )


# smartctl -d scsi -T permissive -T permissive -T permissive -T permissive -s on -x /dev/sdb

smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.10.17]
Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF INFORMATION SECTION ===
Vendor:               JetFlash
Product:              Transcend 256GB
Revision:             1100
Compliance:           SPC-4
User Capacity:        250.054.967.296 bytes [250 GB]
Logical block size:   512 bytes
LU is resource provisioned, LBPRZ=0
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
Logical Unit id:      --removed--
Serial number:        --removed--
Device type:          disk
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
Local Time is:        Thu Mar  4 21:11:57 2021 CET
SMART support is:     Available - device has SMART capability.
SMART support is:     Disabled
Temperature Warning:  Disabled or Not Supported
Read Cache is:        Enabled
Writeback Cache is:   Disabled

=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK
Current Drive Temperature:     0 C
Drive Trip Temperature:        0 C

Error Counter logging not supported

scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
Device does not support Self Test logging
Device does not support Background scan results logging



Better than before. :-)
UAS or not, does not seem to make a difference.
SMART enable does not seem to work :-(


Hope this helps somehow...?
FV