[smartmontools-support] Additional hardware compatibility test for smartmontools

[Nathan Stratton Treadway]

On Sat, Nov 23, 2019 at 15:03:49 -0500, Dan Martin wrote:
> This is with four of those drives connected to a Raspberry Pi 4+ 4GB
> through a Sabrent USB 3.0 powered hub:
> 
> /:  Bus 03.Port 1: Dev 1, Class=root_hub, Driver=dwc_otg/1p, 480M
> /:  Bus 02.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/4p, 5000M
>     |__ Port 2: Dev 2, If 0, Class=Hub, Driver=hub/4p, 5000M
>         |__ Port 1: Dev 3, If 0, Class=Mass Storage, Driver=uas, 5000M
>         |__ Port 2: Dev 4, If 0, Class=Mass Storage, Driver=uas, 5000M
>         |__ Port 3: Dev 5, If 0, Class=Mass Storage, Driver=uas, 5000M
>         |__ Port 4: Dev 6, If 0, Class=Mass Storage, Driver=uas, 5000M
> /:  Bus 01.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/1p, 480M
>     |__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/4p, 480M
>         |__ Port 2: Dev 3, If 0, Class=Hub, Driver=hub/4p, 480M

Great, thanks.

I take it you've been able to use the drives normally in UAS mode (but
with the :u flag turned off via the "usb-storage.quirks=0bc2:2343:"
boot parameter) without any problems?

							Nathan

----------------------------------------------------------------------------
Nathan Stratton Treadway  -  nathanst at ontko.com  -  Mid-Atlantic region
Ray Ontko & Co.  -  Software consulting services  -   http://www.ontko.com/
 GPG Key: http://www.ontko.com/~nathanst/gpg_key.txt   ID: 1023D/ECFB6239
 Key fingerprint = 6AD8 485E 20B9 5C71 231C  0C32 15F3 ADCD ECFB 6239