smartctl 7.0 2019-03-31 r4903 [x86_64-linux-5.2.18-100.fc29.x86_64] (local build) Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: WDC WD5000AZRX-00A8LB0 Firmware Version: 01.01A01 User Capacity: 500 107 862 016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Thu Oct 17 14:01:32 2019 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 8160) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 95) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x30b5) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 138 137 021 - 4075 4 Start_Stop_Count -O--CK 100 100 000 - 135 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 200 200 000 - 0 9 Power_On_Hours -O--CK 098 098 000 - 1934 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 135 192 Power-Off_Retract_Count -O--CK 200 200 000 - 177 193 Load_Cycle_Count -O--CK 197 197 000 - 10173 194 Temperature_Celsius -O---K 114 107 000 - 29 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 200 200 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 200 200 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 1934 - # 2 Short offline Completed without error 00% 1713 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) Device State: Active (0) Current Temperature: 28 Celsius Power Cycle Min/Max Temperature: 24/28 Celsius Lifetime Min/Max Temperature: 18/36 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 478 (231) Index Estimated Time Temperature Celsius 232 2019-10-17 06:04 28 ********* ... ..( 18 skipped). .. ********* 251 2019-10-17 06:23 28 ********* 252 2019-10-17 06:24 ? - 253 2019-10-17 06:25 26 ******* ... ..( 2 skipped). .. ******* 256 2019-10-17 06:28 26 ******* 257 2019-10-17 06:29 27 ******** ... ..( 6 skipped). .. ******** 264 2019-10-17 06:36 27 ******** 265 2019-10-17 06:37 28 ********* 266 2019-10-17 06:38 27 ******** 267 2019-10-17 06:39 27 ******** 268 2019-10-17 06:40 ? - 269 2019-10-17 06:41 24 ***** 270 2019-10-17 06:42 24 ***** 271 2019-10-17 06:43 24 ***** 272 2019-10-17 06:44 25 ****** 273 2019-10-17 06:45 25 ****** 274 2019-10-17 06:46 26 ******* ... ..( 2 skipped). .. ******* 277 2019-10-17 06:49 26 ******* 278 2019-10-17 06:50 27 ******** 279 2019-10-17 06:51 27 ******** 280 2019-10-17 06:52 28 ********* 281 2019-10-17 06:53 28 ********* 282 2019-10-17 06:54 27 ******** 283 2019-10-17 06:55 28 ********* ... ..( 65 skipped). .. ********* 349 2019-10-17 08:01 28 ********* 350 2019-10-17 08:02 ? - 351 2019-10-17 08:03 24 ***** ... ..( 3 skipped). .. ***** 355 2019-10-17 08:07 24 ***** 356 2019-10-17 08:08 25 ****** 357 2019-10-17 08:09 25 ****** 358 2019-10-17 08:10 25 ****** 359 2019-10-17 08:11 26 ******* 360 2019-10-17 08:12 26 ******* 361 2019-10-17 08:13 26 ******* 362 2019-10-17 08:14 27 ******** ... ..( 8 skipped). .. ******** 371 2019-10-17 08:23 27 ******** 372 2019-10-17 08:24 28 ********* ... ..( 16 skipped). .. ********* 389 2019-10-17 08:41 28 ********* 390 2019-10-17 08:42 ? - 391 2019-10-17 08:43 24 ***** ... ..( 2 skipped). .. ***** 394 2019-10-17 08:46 24 ***** 395 2019-10-17 08:47 25 ****** 396 2019-10-17 08:48 25 ****** 397 2019-10-17 08:49 26 ******* ... ..( 3 skipped). .. ******* 401 2019-10-17 08:53 26 ******* 402 2019-10-17 08:54 27 ******** ... ..( 8 skipped). .. ******** 411 2019-10-17 09:03 27 ******** 412 2019-10-17 09:04 28 ********* ... ..( 18 skipped). .. ********* 431 2019-10-17 09:23 28 ********* 432 2019-10-17 09:24 29 ********** ... ..( 8 skipped). .. ********** 441 2019-10-17 09:33 29 ********** 442 2019-10-17 09:34 ? - 443 2019-10-17 09:35 23 **** 444 2019-10-17 09:36 24 ***** 445 2019-10-17 09:37 23 **** 446 2019-10-17 09:38 23 **** 447 2019-10-17 09:39 24 ***** 448 2019-10-17 09:40 24 ***** 449 2019-10-17 09:41 25 ****** 450 2019-10-17 09:42 25 ****** 451 2019-10-17 09:43 26 ******* 452 2019-10-17 09:44 26 ******* 453 2019-10-17 09:45 26 ******* 454 2019-10-17 09:46 27 ******** ... ..( 8 skipped). .. ******** 463 2019-10-17 09:55 27 ******** 464 2019-10-17 09:56 28 ********* ... ..(244 skipped). .. ********* 231 2019-10-17 14:01 28 ********* SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 783 Vendor specific