[Smartmontools-database] HGST HDN726040ALE614

Charles Elliott elliott.ch at comcast.net
Fri May 11 14:25:05 CEST 2018


smartctl 6.5 2016-05-07 r4318 [i686-w64-mingw32-win10(64)] (sf-6.5-1)

Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org

 

=== START OF INFORMATION SECTION ===

Device Model:     HGST HDN726040ALE614

Serial Number:    K7HL757L

LU WWN Device Id: 5 000cca 269d66118

Firmware Version: APGNW7JH

User Capacity:    4,000,787,030,016 bytes [4.00 TB]

Sector Sizes:     512 bytes logical, 4096 bytes physical

Rotation Rate:    7200 rpm

Form Factor:      3.5 inches

Device is:        Not in smartctl database [for details use: -P showall]

ATA Version is:   ACS-2, ATA8-ACS T13/1699-D revision 4

SATA Version is:  SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s)

Local Time is:    Fri May 11 08:16:25 2018 EDT

SMART support is: Available - device has SMART capability.

SMART support is: Enabled

AAM feature is:   Unavailable

APM feature is:   Disabled

Rd look-ahead is: Enabled

Write cache is:   Enabled

ATA Security is:  Disabled, frozen [SEC2]

Wt Cache Reorder: Unknown (0xe001)

 

=== START OF READ SMART DATA SECTION ===

SMART overall-health self-assessment test result: PASSED

 

General SMART Values:

Offline data collection status:  (0x82)      Offline data collection
activity

 
was completed without error.

 
Auto Offline Data Collection: Enabled.

Self-test execution status:      (   0)            The previous self-test
routine completed

 
without error or no self-test has ever 

 
been run.

Total time to complete Offline 

data collection:                                 (  113) seconds.

Offline data collection

capabilities:                                         (0x5b) SMART execute
Offline immediate.

 
Auto Offline data collection on/off support.

 
Suspend Offline collection upon new

 
command.

 
Offline surface scan supported.

 
Self-test supported.

 
No Conveyance Self-test supported.

 
Selective Self-test supported.

SMART capabilities:            (0x0003)           Saves SMART data before
entering

 
power-saving mode.

 
Supports SMART auto save timer.

Error logging capability:        (0x01)             Error logging supported.

 
General Purpose Logging supported.

Short self-test routine 

recommended polling time:         (   2) minutes.

Extended self-test routine

recommended polling time:         ( 571) minutes.

SCT capabilities:                       (0x003d)       SCT Status supported.

 
SCT Error Recovery Control supported.

 
SCT Feature Control supported.

 
SCT Data Table supported.

 

SMART Attributes Data Structure revision number: 16

Vendor Specific SMART Attributes with Thresholds:

ID# ATTRIBUTE_NAME          FLAGS    VALUE WORST THRESH FAIL RAW_VALUE

  1 Raw_Read_Error_Rate     PO-R--   100   100   016    -    0

  2 Throughput_Performance  P-S---   135   135   054    -    112

  3 Spin_Up_Time            POS---   100   100   024    -    0

  4 Start_Stop_Count        -O--C-   100   100   000    -    6

  5 Reallocated_Sector_Ct   PO--CK   100   100   005    -    0

  7 Seek_Error_Rate         PO-R--   100   100   067    -    0

  8 Seek_Time_Performance   P-S---   128   128   020    -    18

  9 Power_On_Hours          -O--C-   100   100   000    -    39

10 Spin_Retry_Count        PO--C-   100   100   060    -    0

12 Power_Cycle_Count       -O--CK   100   100   000    -    3

192 Power-Off_Retract_Count -O--CK   100   100   000    -    8

193 Load_Cycle_Count        -O--C-   100   100   000    -    8

194 Temperature_Celsius     -O----   187   187   000    -    32 (Min/Max
25/41)

196 Reallocated_Event_Count -O--CK   100   100   000    -    0

197 Current_Pending_Sector  -O---K   100   100   000    -    0

198 Offline_Uncorrectable   ---R--   100   100   000    -    0

199 UDMA_CRC_Error_Count    -O-R--   200   200   000    -    0

                            ||||||_ K auto-keep

                            |||||__ C event count

                            ||||___ R error rate

                            |||____ S speed/performance

                            ||_____ O updated online

                            |______ P prefailure warning

 

General Purpose Log Directory Version 1

SMART           Log Directory Version 1 [multi-sector log support]

Address    Access  R/W   Size  Description

0x00       GPL,SL  R/O      1  Log Directory

0x01           SL  R/O      1  Summary SMART error log

0x02           SL  R/O      1  Comprehensive SMART error log

0x03       GPL     R/O      1  Ext. Comprehensive SMART error log

0x04       GPL,SL  R/O      8  Device Statistics log

0x06           SL  R/O      1  SMART self-test log

0x07       GPL     R/O      1  Extended self-test log

0x08       GPL     R/O      2  Power Conditions log

0x09           SL  R/W      1  Selective self-test log

0x10       GPL     R/O      1  SATA NCQ Queued Error log

0x11       GPL     R/O      1  SATA Phy Event Counters log

0x12       GPL     R/O      1  SATA NCQ NON-DATA log

0x15       GPL,SL  R/W      1  SATA Rebuild Assist log

0x21       GPL     R/O      1  Write stream error log

0x22       GPL     R/O      1  Read stream error log

0x24       GPL     R/O    256  Current Device Internal Status Data log

0x25       GPL     R/O    256  Saved Device Internal Status Data log

0x30       GPL,SL  R/O      9  IDENTIFY DEVICE data log

0x80-0x9f  GPL,SL  R/W     16  Host vendor specific log

0xe0       GPL,SL  R/W      1  SCT Command/Status

0xe1       GPL,SL  R/W      1  SCT Data Transfer

 

SMART Extended Comprehensive Error Log Version: 1 (1 sectors)

No Errors Logged

 

SMART Extended Self-test Log Version: 1 (1 sectors)

Num  Test_Description    Status                  Remaining  LifeTime(hours)
LBA_of_first_error

# 1  Short offline       Completed without error       00%        39
-

# 2  Extended offline    Completed without error       00%        28
-

# 3  Extended offline    Aborted by host               60%        18
-

 

SMART Selective self-test log data structure revision number 1

SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS

    1        0        0  Not_testing

    2        0        0  Not_testing

    3        0        0  Not_testing

    4        0        0  Not_testing

    5        0        0  Not_testing

Selective self-test flags (0x0):

  After scanning selected spans, do NOT read-scan remainder of disk.

If Selective self-test is pending on power-up, resume after 0 minute delay.

 

SCT Status Version:                  3

SCT Version (vendor specific):       256 (0x0100)

SCT Support Level:                   1

Device State:                        Active (0)

Current Temperature:                    32 Celsius

Power Cycle Min/Max Temperature:     28/41 Celsius

Lifetime    Min/Max Temperature:     25/41 Celsius

Under/Over Temperature Limit Count:   0/0

 

SCT Temperature History Version:     2

Temperature Sampling Period:         1 minute

Temperature Logging Interval:        1 minute

Min/Max recommended Temperature:      0/60 Celsius

Min/Max Temperature Limit:           -40/70 Celsius

Temperature History Size (Index):    128 (99)

 

Index    Estimated Time   Temperature Celsius

100    2018-05-11 06:09    32  *************

...    ..( 49 skipped).    ..  *************

  22    2018-05-11 06:59    32  *************

  23    2018-05-11 07:00    31  ************

...    ..( 71 skipped).    ..  ************

  95    2018-05-11 08:12    31  ************

  96    2018-05-11 08:13    32  *************

...    ..(  2 skipped).    ..  *************

  99    2018-05-11 08:16    32  *************

 

SMART WRITE LOG returns COUNT and LBA_LOW register unchanged

SCT (Get) Error Recovery Control command failed

 

Device Statistics (GP Log 0x04)

Page  Offset Size        Value Flags Description

0x01  =====  =               =  ===  == General Statistics (rev 2) ==

0x01  0x008  4               3  ---  Lifetime Power-On Resets

0x01  0x018  6      7815927081  ---  Logical Sectors Written

0x01  0x020  6        11447393  ---  Number of Write Commands

0x01  0x028  6         3155681  ---  Logical Sectors Read

0x01  0x030  6            7295  ---  Number of Read Commands

0x01  0x038  6       140584100  ---  Date and Time TimeStamp

0x03  =====  =               =  ===  == Rotating Media Statistics (rev 1) ==

0x03  0x008  4              37  ---  Spindle Motor Power-on Hours

0x03  0x010  4              37  ---  Head Flying Hours

0x03  0x018  4               8  ---  Head Load Events

0x03  0x020  4               0  ---  Number of Reallocated Logical Sectors

0x03  0x028  4              19  ---  Read Recovery Attempts

0x03  0x030  4               0  ---  Number of Mechanical Start Failures

0x04  =====  =               =  ===  == General Errors Statistics (rev 1) ==

0x04  0x008  4               1  ---  Number of Reported Uncorrectable Errors

0x04  0x010  4               0  ---  Resets Between Cmd Acceptance and
Completion

0x05  =====  =               =  ===  == Temperature Statistics (rev 1) ==

0x05  0x008  1              32  ---  Current Temperature

0x05  0x010  1              33  N--  Average Short Term Temperature

0x05  0x018  1               -  N--  Average Long Term Temperature

0x05  0x020  1              41  ---  Highest Temperature

0x05  0x028  1              25  ---  Lowest Temperature

0x05  0x030  1              37  N--  Highest Average Short Term Temperature

0x05  0x038  1              25  N--  Lowest Average Short Term Temperature

0x05  0x040  1               -  N--  Highest Average Long Term Temperature

0x05  0x048  1               -  N--  Lowest Average Long Term Temperature

0x05  0x050  4               0  ---  Time in Over-Temperature

0x05  0x058  1              60  ---  Specified Maximum Operating Temperature

0x05  0x060  4               0  ---  Time in Under-Temperature

0x05  0x068  1               0  ---  Specified Minimum Operating Temperature

0x06  =====  =               =  ===  == Transport Statistics (rev 1) ==

0x06  0x008  4              11  ---  Number of Hardware Resets

0x06  0x010  4               1  ---  Number of ASR Events

0x06  0x018  4               0  ---  Number of Interface CRC Errors

                                |||_ C monitored condition met

                                ||__ D supports DSN

                                |___ N normalized value

 

SATA Phy Event Counters (GP Log 0x11)

ID      Size     Value  Description

0x0001  2            0  Command failed due to ICRC error

0x0002  2            0  R_ERR response for data FIS

0x0003  2            0  R_ERR response for device-to-host data FIS

0x0004  2            0  R_ERR response for host-to-device data FIS

0x0005  2            0  R_ERR response for non-data FIS

0x0006  2            0  R_ERR response for device-to-host non-data FIS

0x0007  2            0  R_ERR response for host-to-device non-data FIS

0x0008  2            0  Device-to-host non-data FIS retries

0x0009  2        28218  Transition from drive PhyRdy to drive PhyNRdy

0x000a  2           11  Device-to-host register FISes sent due to a COMRESET

0x000b  2            0  CRC errors within host-to-device FIS

0x000d  2            0  Non-CRC errors within host-to-device FIS

 

Charles Elliott

316 E Cambria St

Philadelphia, PA 19134

215-425-5222

elliott.ch at comcast.net

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://listi.jpberlin.de/pipermail/smartmontools-database/attachments/20180511/da3f48fa/attachment.html>
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: smartctl-HGST-HDN726040ALE614.txt
URL: <https://listi.jpberlin.de/pipermail/smartmontools-database/attachments/20180511/da3f48fa/attachment.txt>


More information about the Smartmontools-database mailing list