[qutebrowser] viewing bindings

Ryan Roden-Corrent ryan at rcorre.net
Thu Nov 23 14:18:56 CET 2017


Yuusha is correct, however it only applies to command-mode bindings. I don't
know of a good way to do this for other modes. 

-Ryan

On Wed 11/22/17 10:54PM, Yuusha Spacewolf wrote:
> On Thu, Nov 23, 2017 at 02:07:43AM +0000, Stephen Davies (sdavies) wrote:
> > 
> >     If you want to know what command a key is currently bound to, you can
> > type:
> > 
> > :bind thekey
> > 
> >     or
> > 
> > :bind --mode insert thekey
> > 
> >     or whatever.
> > 
> >     What if you want to go the other way? Is there a way to see what key(s)
> > are currently mapped to a particular command, if any?
> > 
> > - Stephen Davies, Ph.D.
> >   (stephen at umw.edu)
> 
> At least on 1.0.3 (and I think it was the same on older versions, but I
> don't have one to test right now) you can see on the right side of the
> completion panel triggered by `:`, the key(s) bound to that command, if
> any.




More information about the qutebrowser mailing list